Kamis, 03 Desember 2009

If the Charge is not Functioning

BlackBerry Curve 8330 Home/Travel ChargerThere are several possible damage if the Charge does not function: The damage occurred on the rechargeable device (charger) battery itself, try your charger on tools other similar device to find broken or not. Battery on your phone is broken so that battery can no longer be refilled. Check whether the connectors on the battery recharging your phone is still good. Then we had to check and test on the phone itself.



  1. If your phone screen appears the message "Not Charging" or cell phone refill process (charging), but indicators of the rechargeable battery run without filling or refilling process (charging), but the indicator remained silent refill it has its Charge IC damaged. Replace with new IC Charge
  2. The phone is finished rechargeable (battery full), but the indicator remained refills keep going, then his power IC damaged. Replace with new Power IC
  3. The phone is not in a state rechargeable (charge), but the indicators continue to refill the road, then the software (SW) is damaged. Perform reprogram (flash) on the phone with the same version.
  4. The phone will be performed every refill process (charge) is always dead, so IC IC Power Charge or damaged. Perform inspection and further testing on the phone to determine whether or IC Charge IC Power and replace damaged or IC Charge IC Power is damaged.
  5. After recharge (charge) phone with a charger, no leaks before the electrical power-on button is pressed, when you press the power button-on, the phone does not work. The cause of the problem is electrical leakage in power supply capacity. The goal remains IC Power, IC UI, PA IC connected to the voltage batteryt VBATT, the units are often damaged and can bring problems is Power IC, IC UI. Because IC Power is BGA, which is integrated IC, then the method is usually done is to release IC UI, then recharge (charge) returned the phone, see if there kobocoran electricity. If not, then IC UI damaged; if any, means that the damaged IC Power. Problems completed, after the replacement of IC described above.
  6. We recharge (charge) phone, then press the ON button, but the phone is off, no electrical current into the phone. If so then do measurements on the R224, if the ends do not have the VBAT voltage 3.2 V, IC Power is damaged or there is a poor soldering on the IC power. Power IC Replace damaged or re-doing soldering on the IC Power
  7. Try to re-flash the way your phone





0 komentar:

Posting Komentar